Differences

This shows you the differences between two versions of the page.

--- axumgsmhybridremote:start [2022/02/15 10:59] – created support
+++ axumgsmhybridremote:start [2022/02/15 11:14] – support
@@ Line 2: / Line 2: @@
 ^**__Question:__** How can I configure my GSM Hybrid GPO to Alert on my Axum and GPI to pickup/hangup?^
 |**__Answer:__** Link: [[axumgsmhybridremote:start|follow the instructions on this page.]]|
+\\
+{{:axumstudioremote:micad.jpg?600|}}\\
+First you'll need to set the jumpers for one GPO to GPIO the other one remains GPO.\\
+For the GPIO Jack A which is GPI7 on a patch panel you'll need to change the bottom row of jumpers to 1-2 & 4-5.\\
+The top row remains at 2-3 & 5-6 which is GPO8.\\
+\\
+{{:axumgsmhybridremote:gsmhybridgpio.png?600|}}\\
+At a card where you connected the GSM Hybrid to you'll need to configure a GPO to switch when Start/Stop is triggered.\\
+You'll also need to configure a GPI to trigger the Line inputs Alert function.\\
+\\
+{{:axumgsmhybridremote:gsmhybridringpickup.png?600|}}\\
+To pick up or hang up the GSM Hybrid you'll need to configure a switch for Start and Stop function.\\
+\\
+{{:axumgsmhybridremote:gsmhybridringalert.png?600|}}\\
+Now you can configure a desired LED or meters icon to input and it's Alert function to go on or blink when the GSM Hybrid rings.\\
+\\
+[[https://www.d-r.nl/support-request.html|Support Request]]\\
+\\
+[[start:|{{:iconhome.png?100|Home}}]][[SupAxum:start|{{:iconback2.png?100|Back}}]]
 \\