Differences

This shows you the differences between two versions of the page.

--- faderstartairlab:start [2019/06/07 16:39] – support
+++ faderstartairlab:start [2019/07/22 09:30] – support
@@ Line 1: / Line 1: @@
+The easiest way to change the fader start settings in an Airlab is the Airlab Control Center.\\
+Connect your Airlab to your PC by RS-232 cable or RS-232 to USB cable.\\
+\\
+Be carefull not to connect to the **__Meter__** connector cause the **__+15 volt and -15 volt__** will harm the computer port.\\
+\\
 {{ :faderstartinstr:airlab_gpo_settings.png?direct |}}\\
+\\
+\\
+Another way is to go into the setup by using the buttons and display at the Master section.\\
+\\
 {{ :faderstartinstr:airlab_gpo_settings_a.png?direct |}}\\
 {{ :faderstartinstr:airlab_gpo_settings_b.png?direct |}}\\
@@ Line 5: / Line 14: @@
 \\
 [[faderstartinstr:start|Return to Fader start instructions]]\\
+\\
+[[https://www.d-r.nl/support-request.html|Support Request]]\\
+\\
+Go back to the [[SupAirlab:start|Airlab]] support page.\\
+\\