**__Question:__** How do I setup Aircast to work with my Airlab \\
**__Answer:__** [[aircastairlab:start|please follow the steps at this link]]\\

===== Easy setup manual Aircast with an Airlab 2/3 =====

{{ :supaircast:10_control_panel.png?direct |}}\\
For the non visual configuration you can go to the Aircast Control panel.\\

{{ :supaircast:airlab_backpanel_master_section.jpg?direct |}}\\
On this backplane you see the output Master in Red coming in on two USB Audio codecs.\\
The Sub bus in Green coming in at two USB Audio codecs.\\

{{ :supaircast:03b_sound_settings_usb_input_change_names.png?direct |}}\\
Here you see the Windows Sound settings with the corresponding inputs highlighted with colors to easily recognize them.\\

{{ :supaircast:04b_sound_settings_usb_output_change_names.png?direct |}}\\
Here you see the Windows Sound settings with the corresponding outnputs highlighted with colors to easily recognize them.\\

{{ :supaircast:11_configuration_player_audio.png?direct |}}\\
  * Player 1 plays to Channel 1 and it’s PFL goes to Channel 4\\
  * Player 2 plays to Channel 2 and it’s PFL goes to Channel 4\\
  * Player 3 plays to Channel 3 and it’s PFL goes to Channel 4\\
  * The standard playout goes to Channel 1, the standard PFL goes to Channel 4, the standard recording device is Program (Non Stop)\\

{{ :supaircast:12_configuration_cartwall_audio.png?direct |}}\\
  * All the Cartwall players playout to channel 4

{{ :supaircast:13_configuration_encoder_pfl_vt.png?direct |}}\\
  * To listen to the encoder you can select Channel 4\\
  * it’s line in signal comes from the Prog (Non Stop).\\
  * as an Aux signal it receives the Aux.\\
  * The PFL player comes out of Channel 4.\\

  * For the Voicetrack recorder we tell Aircast that Player A is Channel 1.\\
  * Player B is Channel 2.\\
  * Cartwall is Channel 4 as well as the Mic Monitor.\\
  * The Microphone input is the Sub / Voice track bus.

{{ :supaircast:14_configuration_air_check.png?direct |}}\\

  * To record the Aircheck you can use different inputs.\\
  * in this case we selected Prog (Non Stop) but this can also be the on air input at an Airlite.\\
  * The Live Feed uses the Prog (Non stop) input.\\

[[start:|{{:iconhome.png?100|Home}}]][[SupAirlab:start|{{:iconback2.png?100|Back}}]][[aircastairlab:start|{{:iconback1.png?100|Back}}]][[aircastairlab3:start|{{:iconforw.png?100|please follow the steps at the second page}}]]