\\
**__Question:__** How can I configure my Axum to control Aircast? \\
\\
**__Answer:__** Link: [[axumaircast:start|follow the instructions on this page]] \\
\\
------
\\
{{ :axumaircast:axum_en_aircast_1.png?direct |}}
\\
At the __configuration panel__ add __D&R AXUM (MambaNet)__ in the __Remote Control__ panel.\\
\\
{{ :axumaircast:axum_en_aircast_2.png?direct |}}
\\
Then go to __Configure__ and set the Communication to __UDP__ and for the IP address fill in the IP address of the Axum Rack.\\
\\
{{ :axumaircast:axum_en_aircast_3.png?direct |}}
\\
When you apply the Aircast node will show in the __Register information__ page of the Axum as __Test Name__\\
\\
{{ :axumaircast:axum_en_aircast_4.png?direct |}}
\\
This node can be renamed to Aircast.\\
\\
{{ :axumaircast:axum_en_aircast_5.png?direct |}}
\\
When you go to __Surface configuration__ you'll find the Aircast node.\\
\\
{{ :axumaircast:axum_en_aircast_6.png?direct |}}
\\
When you press the __configure__ button you'll see the empty function list for this node.\\
\\
{{ :axumaircast:axum_en_aircast_7.png?direct |}}
\\
Now you can configure the Actuators that will trigger the 16 virtual busses that will go to Aircast.\\
\\
So when you for example configure __Module x: Fader on__ the Axum will send a trigger to Aircast when that fader is going from off to on.\\
\\
{{ :axumaircast:axum_en_aircast_8.png?direct |}}
\\
Now at the Aircast __Control Panel__ in the __D&R Axum (Mambanet)__ at the __Commands__ tab you can configure for each Actuator what the function needs to be when the Axum sends it's trigger.\\
\\
\\
{{ :axumaircast:axum_en_aircast.png?direct |}}
\\
Multiple functions can be configured this way.\\
\\
[[https://www.dnrbroadcast.com/support-related|Support Request]]\\
\\
[[start:|{{:iconhome.png?100|Home}}]][[SupAxum:start|{{:iconback2.png?100|Back}}]]
\\