====== FAQ - Hybrid-2 ======

^  Model:  ^^  Production year  ^
|  Hybrid 2  ||  -  |
|  {{:tel-hybrid-2-2015_2x.png?200|}}  |||
|  [[http://www.mambanet.org/assets/hybrid1-2-brochure.pdf|Brochure]]  |  [[http://www.mambanet.org/assets/hybrid-2-manual-smd-1.04.pdf|Manual]]  |  -  |

\\
^**__Question:__** Could you give us an explanation about the dip switch of C-BALANCE?^
|**__Answer:__** The R balance works as an N-1 and can be set with connecting the input and listening at the output.|
|Set the Send and Receive in the middle and the LC and HC to OFF.|
|When called in adjust the potentiometer until the lowest input signal is heared.|
|  |
|The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.|
|So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn't change.|
|When this is okay you can fine adjust the R balance.|
|  |
|The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.|
\\
-----
\\
  * [[http://www.mambanet.org/wiki/dokudata/faq/hybrid2/HYBRID-2 RING VOLTAGE MEMO.pdf|HYBRID-2 RING VOLTAGE MEMO]]
\\
[[start:|{{:iconhome.png?100|Home}}]]