D&R Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
**__Question:__** How do I setup Aircast to work with my Airlab \\
**__Answer:__** Link: [[aircastairlab:start|please follow the steps at this link]]\\

===== Easy setup manual Aircast with an Airlab 1/3 =====

In this Easy setup manual you’ll learn how to set up Aircast with you’re mixer by following the configuration pictures.\\

{{ :supaircast:01_sound_settings.png?direct |}}\\
First you'll have to make it easier to identify your USB Audio Codecs.\\
Go to the sound settings of your Windows.\\

{{ :supaircast:02_sound_settings_usb_input_names.png?direct |}}\\
So for all the USB audio codecs you'll need to play the Test sounds to determine to which channel the USB Audio Codec is connected in your mixer.\\

{{ :supaircast:03_sound_settings_usb_input_change_names.png?direct |}}\\
You can rename them after double clicking on the USB Audio Codec.\\

{{ :supaircast:04_sound_settings_usb_output_change_names.png?direct |}}\\
The same has to be done for all the outputs to the computer.\\
This can be done with a Microphone connected to a Mic channel.\\
  * First test with only the ON activated and look at the small VU meter in the window, this one will be __Program__.
  * Then hold down the ON button till it starts blinking to activate the __Voice Track__ bus.
  * Press the on button twice to return to the normal ON state.
  * Turn the __Aux__ potentiometer (Full open) of the channel and the __Aux Send__ (2 O'Clock) (Under the VU meter) to see where the __Aux__ signal comes in.
  * The last one is the __On Air__

{{youtube>1mD7JKfRlD0}}
[[https://www.youtube.com/watch?v=1mD7JKfRlD0|We also have an instruction video that shows how this has to be done]]

{{ :supaircast:05_configuration.png?direct |}}\\
All visual settings have to be done in the configuration tool and the rest can be done at the Control panel in Aircast.\\

{{ :supaircast:06_player_count.png?direct |}}\\
To use Aircast with 3 players you’ll have to go to the Aircast configuration tool and change Player count to the right amount of players.\\

{{ :supaircast:07_cartwall_player_count.png?direct |}}\\
The same can be done with the amount of Cartwall players, you’ll have to change the Width and Height.\\
A Width of 4 and a Height of 2 creates 8 players.\\

{{ :supaircast:08_screen_objects.png?direct |}}\\
It is also possible to add Screen objects like the Aircheck recorder, LED clock, PFL player etc.\\

{{ :supaircast:09_encoder.png?direct |}}\\
Also the Program recorder, shoutcast stream server are visible options so they'll have to be added in the Configuration tool.\\

{{ :supaircast:24_configuration_airlab_rs232.png?direct |}}\\
To use the Fader starts of an Airlab you'll also need to set the Serial port settings to the right Baud rate.\\

[[start:|{{:iconhome.png?100|Home}}]][[SupAirlab:start|{{:iconback2.png?100|Back}}]][[aircastairlab2:start|{{:iconforw.png?100|please follow the steps at the second page}}]]