aircastwebstation:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
aircastwebstation:start [2018/12/12 09:24] – support | aircastwebstation:start [2022/01/25 16:36] (current) – support | ||
---|---|---|---|
Line 22: | Line 22: | ||
* Then hold down the ON button till it starts blinking to activate the __Voice Track__ bus. | * Then hold down the ON button till it starts blinking to activate the __Voice Track__ bus. | ||
* Press the on button twice to return to the normal ON state. | * Press the on button twice to return to the normal ON state. | ||
- | | + | * The last one is also the __Voip__ |
- | | + | |
{{youtube> | {{youtube> | ||
Line 44: | Line 43: | ||
Also the Program recorder, shoutcast stream server are visible options so they' | Also the Program recorder, shoutcast stream server are visible options so they' | ||
- | {{ :supaircast:24_configuration_airlab_rs232.png?direct | + | [[start:|{{:iconhome.png? |
- | To use the Fader starts of an Airlab you'll also need to set the Serial port settings to the right Baud rate.\\ | + | |
- | [[aircastwebstation2: |
aircastwebstation/start.1544603081.txt.gz · Last modified: 2018/12/12 09:24 by support