airlabversion:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
airlabversion:start [2018/12/12 14:03] – support | airlabversion:start [2022/07/18 09:16] (current) – support | ||
---|---|---|---|
Line 30: | Line 30: | ||
| DT V.4 | Airlab master boards to SMD | | | DT V.4 | Airlab master boards to SMD | | ||
| | Airlab backplane changed to Lisheng XLR | | | | Airlab backplane changed to Lisheng XLR | | ||
+ | \\ | ||
+ | ^ Airlab channel, USB, Dig, Voip ^ MK2 ^ DT ^ | ||
+ | | Relais | ||
+ | | Resistor R 93 | 2K7 Ohm | 3K48 Ohm | | ||
+ | \\ | ||
+ | ^ Airlab Telco ^ MK2 ^ DT ^ | ||
+ | | Relais RL 1 | 12 volt | 5 volt (no relais at connector PCB, connected with 0 Ohm) | | ||
+ | | Diode Z1 | Zener 8,2 volt | 1N4148 | ||
+ | | Resistor R52 | 120 Ohm | Not placed | ||
+ | | Resistor R 93 | 2K7 Ohm | 3K48 Ohm | | ||
+ | \\ | ||
+ | \\ | ||
+ | ^ Airlab 1x ^ Airlab 10x ^ Airlab PCB info ^ | ||
+ | | Airlab 10A with reed relais (2 jacks) | ||
+ | | | | | ||
+ | | Airlab 10A with reed relais (2 jacks) | ||
+ | | | | | ||
+ | | Airlab 10A with reed relais (2 jacks) | ||
+ | | Airlab 10B with reed relais (3 jacks) | ||
+ | | | | (non insert connect J11) | | ||
+ | | Airlab 10B with reed relais (3 jacks) | ||
+ | | | | (non insert connect J11) | | ||
+ | ^ ^ ^ ^ | ||
+ | | Airlab 10B without reed relais (3 jacks) | ||
+ | | - | - | (non insert connect insert jack at 10B) | | ||
+ | ^ ^ ^ ^ | ||
+ | | Airlab 10A SMT without reed relais insert (3 jacks) | ||
+ | | - | - | (non insert connect jack at 10B) | | ||
+ | \\ | ||
+ | \\ | ||
+ | [[https:// | ||
+ | \\ | ||
+ | [[start: | ||
+ | \\ |
airlabversion/start.1544619804.txt.gz · Last modified: 2018/12/12 14:03 by support