Differences

This shows you the differences between two versions of the page.

--- axumdante:start [2021/11/02 10:11] – support
+++ axumdante:start [2022/06/03 13:49] – support
@@ Line 5: / Line 5: @@
 -----
 \\
-==== The "Dante card" will only work completely in 16 channel slots of the Axum rack positioned between the DSP card and the Rack ETX. ====
+==== In units produced after 05-05-2021 the Dante card will completly work from slot 12 and higher due to a firmware update. ====
-==== In units produced after 05-05-2021 the Dante card will work from slot 12 and higher due to a firmware update. ====
+==== At units produced after 27-02-2020 the Dante card will completly work in slots 16 to 19. ====
+==== For units produced before 27-02-2020 take a look at our version table. ====
+\\
+^**__Question:__** What are the differences in versions?^
+|**__Answer:__** Link: [[axumversion:start|please read the info at this link]]|
 \\
 -----
@@ Line 47: / Line 51: @@
 \\
 First it is important that the AXUM dante module is in Sync showing a green square.\\
+\\
+{{:axumdante:axumclockmasterrackconfiguration.png?direct|}}
+\\
+Default we deliver the system with the Axum being Clock Master.\\
+This can be set with the blue dot in the Rack Configuration page.\\
+\\
+{{:axumdante:axumclockmasterrackconfigurationdantecard.png?direct|}}
+\\
+Sometimes when there has been some issues it works better when you set it in the Cards configuration at the Enable word clock setting.\\
+\\
+{{:axumdante:danteclockmasterrackconfiguration.png?direct|}}
+\\
+When you use more Dante equipment in your system it can be usefull to set the Dante card as clock master.\\
+\\
+{{:axumdante:danteclockmasterrackconfigurationdantecard.png?direct|}}
+\\
+When you have issues it can help to change the setting in the cards configuration.\\
 \\
 {{:axumdante:dantecontrolleraxumin.png?direct|}}