axumpsu:start
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| axumpsu:start [2019/08/07 10:49] – created support | axumpsu:start [2020/12/08 13:08] (current) – support | ||
|---|---|---|---|
| Line 28: | Line 28: | ||
| - Now fine adjust the potentiometer at the front (Orange circle) until you measure 5.15 volts for a single power supply or 5.20 volts for a reduntant power supply. | - Now fine adjust the potentiometer at the front (Orange circle) until you measure 5.15 volts for a single power supply or 5.20 volts for a reduntant power supply. | ||
| - Repeat these steps for the second power supply. | - Repeat these steps for the second power supply. | ||
| - | - The voltage measured at the trough hole (Yellow circle) of the backplane should be near -15.80 volts. | + | - The voltage measured at the measure point (Yellow circle) of the backplane should be near -15 volts (-16 is also okay). |
| - | - The voltage measured at the trough hole (Purple circle) of the backplane should be near +15.80 volts. | + | - The voltage measured at the measure point (Purple circle) of the backplane should be near +15 volts (+16 is also okay). |
| + | \\ | ||
| + | [[start: | ||
axumpsu/start.1565167782.txt.gz · Last modified: 2019/08/07 10:49 by support