axumstudioremote:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
axumstudioremote:start [2019/04/30 10:06] – support | axumstudioremote:start [2022/07/18 09:17] (current) – support | ||
---|---|---|---|
Line 1: | Line 1: | ||
**__Question: | **__Question: | ||
**__Answer: | **__Answer: | ||
+ | \\ | ||
To connect a Studio remote to your Axum you'll have to change the Jumpers on the MicAD card to GPIO instead of GPO settings.\\ | To connect a Studio remote to your Axum you'll have to change the Jumpers on the MicAD card to GPIO instead of GPO settings.\\ | ||
+ | \\ | ||
{{ : | {{ : | ||
+ | \\ | ||
Set the Jumpers to the 1-2 and 4-5 Jumper positions.\\ | Set the Jumpers to the 1-2 and 4-5 Jumper positions.\\ | ||
+ | \\ | ||
Then you can configure the functions of this GPIO' | Then you can configure the functions of this GPIO' | ||
+ | \\ | ||
{{ : | {{ : | ||
+ | \\ | ||
In this example the Studio remote will show when the user presses the Cough and Comm button.\\ | In this example the Studio remote will show when the user presses the Cough and Comm button.\\ | ||
An other option can be to show the Redlight connected to the Microphone input.\\ | An other option can be to show the Redlight connected to the Microphone input.\\ | ||
+ | \\ | ||
Setting 1027 - 1034 are the GPI settings and react to the buttons of the Studio Remote.\\ | Setting 1027 - 1034 are the GPI settings and react to the buttons of the Studio Remote.\\ | ||
Setting 1051 - 1058 are the GPO settings and will make the LED's of the Studio Remote go ON.\\ | Setting 1051 - 1058 are the GPO settings and will make the LED's of the Studio Remote go ON.\\ | ||
- | + | \\ | |
- | [[SupAxum: | + | [[https:// |
+ | \\ | ||
+ | [[start: | ||
+ | \\ |
axumstudioremote/start.1556611605.txt.gz · Last modified: 2019/04/30 10:06 by support