D&R Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

The easiest way to change the fader start settings in an Airlab is the Airlab Control Center.\\
Connect your Airlab to your PC by RS-232 cable or RS-232 to USB cable.\\
\\
Be carefull not to connect to the **__Meter__** connector cause the **__+15 volt and -15 volt__** will harm the computer port.\\
\\
{{ :faderstartinstr:airlab_gpo_settings.png?direct |}}\\
\\
\\
Another way is to go into the setup by using the buttons and display at the Master section.\\
\\
{{ :faderstartinstr:airlab_gpo_settings_a.png?direct |}}\\
{{ :faderstartinstr:airlab_gpo_settings_b.png?direct |}}\\
{{ :faderstartinstr:airlab_gpo_settings_c.png?direct |}}\\
\\
[[faderstartinstr:start|Return to Fader start instructions]]\\
\\
[[https://www.dnrbroadcast.com/support-related|Support Request]]\\
\\
Go back to the [[SupAirlab:start|Airlab]] support page.\\
\\