faderstartairlab:start
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
faderstartairlab:start [2019/06/07 16:35] – created support | faderstartairlab:start [2022/07/18 09:18] (current) – support | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | The easiest way to change the fader start settings in an Airlab is the Airlab Control Center.\\ | ||
+ | Connect your Airlab to your PC by RS-232 cable or RS-232 to USB cable.\\ | ||
+ | \\ | ||
+ | Be carefull not to connect to the **__Meter__** connector cause the **__+15 volt and -15 volt__** will harm the computer port.\\ | ||
+ | \\ | ||
+ | {{ : | ||
+ | \\ | ||
+ | \\ | ||
+ | Another way is to go into the setup by using the buttons and display at the Master section.\\ | ||
+ | \\ | ||
+ | {{ : | ||
+ | {{ : | ||
+ | {{ : | ||
+ | \\ | ||
[[faderstartinstr: | [[faderstartinstr: | ||
+ | \\ | ||
+ | [[https:// | ||
+ | \\ | ||
+ | Go back to the [[SupAirlab: | ||
+ | \\ | ||
+ |
faderstartairlab/start.1559918159.txt.gz · Last modified: 2019/06/07 16:35 by support