nwfwupdate:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
nwfwupdate:start [2019/07/22 09:24] – support | nwfwupdate:start [2022/06/09 09:01] – support | ||
---|---|---|---|
Line 4: | Line 4: | ||
==== Step 1 ==== | ==== Step 1 ==== | ||
- | * Be sure that the USB cable is connected. | + | * Be sure that the USB cable is connected.\\ |
- | * Be sure that the original USB cable is used or a cable with a maximum length of 1,8 meter (6ft). | + | * Be sure that the original USB cable is used or a cable with a maximum length of 1,8 meter (6ft).\\ |
- | * Don't use Extender cables or Hubs, connect it to a port directly on the mainboard. | + | * Don't use Extender cables or Hubs, connect it to a port directly on the mainboard.\\ |
- | * Did you download and select | + | * When connecting |
+ | * Did you download and select the right firmware?\\ | ||
+ | \\ | ||
==== Step 2 ==== | ==== Step 2 ==== | ||
Line 36: | Line 38: | ||
Also take a look at this document: | Also take a look at this document: | ||
- | [[https://www.d-r.nl/ | + | [[http://www.mambanet.org/ |
==== Step 6 ==== | ==== Step 6 ==== | ||
Line 43: | Line 45: | ||
\\ | \\ | ||
[[https:// | [[https:// | ||
+ | \\ | ||
+ | Go back to the [[SupAirence: | ||
\\ | \\ | ||
Go back to the [[SupAirlab: | Go back to the [[SupAirlab: | ||
Line 52: | Line 56: | ||
Go back to the [[SupGSMHybrid: | Go back to the [[SupGSMHybrid: | ||
\\ | \\ | ||
+ | [[start: |
nwfwupdate/start.txt · Last modified: 2022/07/18 09:03 by support