Differences

This shows you the differences between two versions of the page.

--- nwfwupdate:start [2019/07/22 09:31] – support
+++ nwfwupdate:start [2020/03/25 16:02] – support
@@ Line 4: / Line 4: @@
 ==== Step 1 ====
-  * Be sure that the USB cable is connected.
+  * Be sure that the USB cable is connected.\\
-  * Be sure that the original USB cable is used or a cable with a maximum length of 1,8 meter (6ft).
+  * Be sure that the original USB cable is used or a cable with a maximum length of 1,8 meter (6ft).\\
-  * Don't use Extender cables or Hubs, connect it to a port directly on the mainboard.
+  * Don't use Extender cables or Hubs, connect it to a port directly on the mainboard.\\
-  * Did you download and select the right firmware?
+  * When connecting the unit did you receive an error that there aren't enough end points or resources? Then there is probably an xHCI or different usb problem. [[usbnotworking:start|Please follow the steps at this link]]
+  * Did you download and select the right firmware?\\
+\\
 ==== Step 2 ====