D&R Wiki

User Tools

Site Tools

Trace:
supairence:start

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
supairence:start [2022/06/10 09:10] – supportsupairence:start [2022/07/14 10:13] (current) – support
Line 17: Line 17:
 To set the unit in bootloader mode: To set the unit in bootloader mode:
   - Take off the Power off the unit   - Take off the Power off the unit
-  - Hold down the "Encoder" of the "Control surface" +  - Hold down the "Encoder" (Data) of the "Control surface" 
-  - While holding down the "Encoder" you'll have to "Power on" the unit +  - While holding down the "Encoder" (Data) you'll have to "Power on" the unit 
-  - Release the "Encoder" after 5 seconds+  - Release the "Encoder" (Data) after 5 seconds
   - The Unit will show some random LED's as there is no software loaded at this moment   - The Unit will show some random LED's as there is no software loaded at this moment
 \\ \\
supairence/start.txt · Last modified: 2022/07/14 10:13 by support