Differences

This shows you the differences between two versions of the page.

--- supairence:start [2022/05/20 09:49] – support
+++ supairence:start [2022/07/14 10:13] – support
@@ Line 17: / Line 17: @@
 To set the unit in bootloader mode:
   - Take off the Power off the unit
-  - Hold down the "Encoder" of the "Control surface"
+  - Hold down the "Encoder" (Data) of the "Control surface"
-  - While holding down the "Encoder" you'll have to "Power on" the unit
+  - While holding down the "Encoder" (Data) you'll have to "Power on" the unit
-  - Release the "Encoder" after 5 seconds
+  - Release the "Encoder" (Data) after 5 seconds
   - The Unit will show some random LED's as there is no software loaded at this moment
 \\
+If you receive a Error 740, it means that it requires elevation to run.\\
+Meaning you must run it as administrator.\\
+Try right clicking the command prompt and running it as administrator.\\
 \\
 ^  Needed Software  ^  Windows 7 {{:compatibility-windows-7.jpg?80|}}  ^  Windows 8 {{:compatibility-windows-8.jpg?80|}}  ^  Windows 10 {{:compatibility-windows-10.jpg?80|}}  ^  Windows 11 {{:compatibility-windows-11.jpg?80|}}  ^  MAC OS X {{:compatibility-mac.jpg?80|}}  ^  Linux\\ {{:compatibility-linux.jpg?90|}}  ^  Manual\\ & Info  ^