supairence:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
supairence:start [2022/05/20 09:49] – support | supairence:start [2023/04/12 16:43] – roger | ||
---|---|---|---|
Line 8: | Line 8: | ||
\\ | \\ | ||
- | ====== Attention | + | ====== Attention |
- | ^ Be carefull due to a hardware change it is NOT possible to combine older versions with units produced after 01-01-2022 | + | ^ Be carefull due to a hardware change it is NOT possible to combine older versions with units produced after 01-01-2022 |
- | | V.10 Main\\ V.10 Extender | + | | V.10 Main\\ V.10 Extender |
\\ | \\ | ||
Install as Administrator :!: \\ | Install as Administrator :!: \\ | ||
Line 17: | Line 17: | ||
To set the unit in bootloader mode: | To set the unit in bootloader mode: | ||
- Take off the Power off the unit | - Take off the Power off the unit | ||
- | - Hold down the " | + | - Hold down the " |
- | - While holding down the " | + | - While holding down the " |
- | - Release the " | + | - Release the " |
- The Unit will show some random LED's as there is no software loaded at this moment | - The Unit will show some random LED's as there is no software loaded at this moment | ||
\\ | \\ | ||
+ | If you receive a Error 740, it means that it requires elevation to run.\\ | ||
+ | Meaning you must run it as administrator.\\ | ||
+ | Try right clicking the command prompt and running it as administrator.\\ | ||
\\ | \\ | ||
^ Needed Software | ^ Needed Software |
supairence/start.txt · Last modified: 2024/02/14 22:47 by jeroenbol