Differences

This shows you the differences between two versions of the page.

--- supairence:start [2022/06/10 09:10] – support
+++ supairence:start [2022/07/14 10:13] – support
@@ Line 17: / Line 17: @@
 To set the unit in bootloader mode:
   - Take off the Power off the unit
-  - Hold down the "Encoder" of the "Control surface"
+  - Hold down the "Encoder" (Data) of the "Control surface"
-  - While holding down the "Encoder" you'll have to "Power on" the unit
+  - While holding down the "Encoder" (Data) you'll have to "Power on" the unit
-  - Release the "Encoder" after 5 seconds
+  - Release the "Encoder" (Data) after 5 seconds
   - The Unit will show some random LED's as there is no software loaded at this moment
 \\