Differences

This shows you the differences between two versions of the page.

--- supairence:start [2022/06/10 09:10] – support
+++ supairence:start [2023/04/12 16:43] – roger
@@ Line 8: / Line 8: @@
 \\
-====== Attention ! ======
+====== Attention  ======
-^  Be carefull due to a hardware change it is NOT possible to combine older versions with units produced after 01-01-2022 !!!  ^^^
+^  Be carefull due to a hardware change it is NOT possible to combine older versions with units produced after 01-01-2022   ^^^
-|  V.10 Main\\ V.10 Extender  |  01-01-2022  |  POWER SUPPLY CHANGED TO 12 VOLT INSTEAD OF THE EARLIER USED 36 VOLT\\  MAIN V.10 and EXTENDER V.10 ARE NOT COMPATIBLE WITH OLDER VERSIONS !!!\\ Connecting a older to a newer units will damage the older unit !!!  |
+|  V.10 Main\\ V.10 Extender  |  01-01-2022  |  POWER SUPPLY CHANGED TO 12 VOLT INSTEAD OF THE EARLIER USED 36 VOLT\\  MAIN V.10 and EXTENDER V.10 ARE NOT COMPATIBLE WITH OLDER VERSIONS !!!\\ Connecting a older to a newer units will damage the older unit   |
 \\
 Install as Administrator :!: \\
@@ Line 17: / Line 17: @@
 To set the unit in bootloader mode:
   - Take off the Power off the unit
-  - Hold down the "Encoder" of the "Control surface"
+  - Hold down the "Encoder" (Data) of the "Control surface"
-  - While holding down the "Encoder" you'll have to "Power on" the unit
+  - While holding down the "Encoder" (Data) you'll have to "Power on" the unit
-  - Release the "Encoder" after 5 seconds
+  - Release the "Encoder" (Data) after 5 seconds
   - The Unit will show some random LED's as there is no software loaded at this moment
 \\