suphybrid1:start
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
suphybrid1:start [2018/12/10 13:25] – created support | suphybrid1:start [2021/04/29 16:43] (current) – support | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== Hybrid 1 ===== | ===== Hybrid 1 ===== | ||
+ | |||
+ | ^ Model: | ||
+ | | Hybrid 1 || - | | ||
+ | | {{: | ||
+ | | [[http:// | ||
+ | |||
+ | \\ | ||
+ | ^**__Question: | ||
+ | |**__Answer: | ||
+ | \\ | ||
+ | ^**__Question: | ||
+ | |**__Answer: | ||
+ | |When called in adjust the potentiometer until the lowest input signal is heared.| | ||
+ | | | | ||
+ | |The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.| | ||
+ | |So if you apply a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn' | ||
+ | |When this is okay you can fine adjust the R balance.| | ||
+ | | | | ||
+ | |The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.| | ||
+ | \\ | ||
+ | [[start: |
suphybrid1/start.1544444714.txt.gz · Last modified: 2018/12/10 13:25 by support