suphybrid1:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
suphybrid1:start [2019/07/26 11:49] – support | suphybrid1:start [2021/04/29 16:43] (current) – support | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== Hybrid 1 ===== | ===== Hybrid 1 ===== | ||
- | **__Question:__** Could you give us an explanation about the dip switch of C-BALANCE?\\ | + | ^ Model: |
- | **__Answer:__** The R balance works as an N-1 and can be set with connecting the input and listening at the output.\\ | + | | Hybrid 1 || |
- | Set the Send and Receive in the middle and the LC and HC to OFF.\\ | + | | {{: |
- | When called in adjust the potentiometer until the lowest input signal is heared.\\ | + | | [[http:// |
\\ | \\ | ||
- | The C balance should be set to the situation that the Hybrid | + | ^**__Question: |
- | So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn' | + | |**__Answer: |
- | When this is okay you can fine adjust the R balance.\\ | + | |
\\ | \\ | ||
- | The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.\\ | + | ^**__Question: |
+ | |**__Answer: | ||
+ | |When called in adjust the potentiometer until the lowest input signal is heared.| | ||
+ | | | | ||
+ | |The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.| | ||
+ | |So if you apply a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn' | ||
+ | |When this is okay you can fine adjust the R balance.| | ||
+ | | | | ||
+ | |The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.| | ||
\\ | \\ | ||
+ | [[start: |
suphybrid1/start.1564134594.txt.gz · Last modified: 2019/07/26 11:49 by support