suphybrid1:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
suphybrid1:start [2020/05/29 10:08] – support | suphybrid1:start [2021/04/29 16:43] (current) – support | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== Hybrid 1 ===== | ===== Hybrid 1 ===== | ||
- | {{: | + | |
+ | ^ Model: | ||
+ | | Hybrid 1 || - | | ||
+ | | | ||
+ | | [[http:// | ||
\\ | \\ | ||
^**__Question: | ^**__Question: | ||
- | |**__Answer: | + | |**__Answer: |
\\ | \\ | ||
^**__Question: | ^**__Question: | ||
|**__Answer: | |**__Answer: | ||
- | |Set the Send and Receive in the middle and the LC and HC to OFF.| | ||
|When called in adjust the potentiometer until the lowest input signal is heared.| | |When called in adjust the potentiometer until the lowest input signal is heared.| | ||
| | | | | | ||
|The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.| | |The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.| | ||
- | |So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn' | + | |So if you apply a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn' |
|When this is okay you can fine adjust the R balance.| | |When this is okay you can fine adjust the R balance.| | ||
| | | | | | ||
|The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.| | |The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.| | ||
\\ | \\ | ||
+ | [[start: |
suphybrid1/start.1590739701.txt.gz · Last modified: 2020/05/29 10:08 by support