suphybrid2:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
suphybrid2:start [2019/06/21 16:03] – support | suphybrid2:start [2021/03/29 10:04] (current) – support | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== FAQ - Hybrid-2 ====== | ====== FAQ - Hybrid-2 ====== | ||
+ | |||
+ | ^ Model: | ||
+ | | Hybrid 2 || - | | ||
+ | | {{: | ||
+ | | [[http:// | ||
+ | |||
+ | \\ | ||
+ | ^**__Question: | ||
+ | |**__Answer: | ||
+ | |Set the Send and Receive in the middle and the LC and HC to OFF.| | ||
+ | |When called in adjust the potentiometer until the lowest input signal is heared.| | ||
+ | | | | ||
+ | |The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.| | ||
+ | |So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn' | ||
+ | |When this is okay you can fine adjust the R balance.| | ||
+ | | | | ||
+ | |The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.| | ||
\\ | \\ | ||
----- | ----- | ||
\\ | \\ | ||
- | * [[https://www.d-r.nl/ | + | * [[http://www.mambanet.org/ |
- | \\ | + | |
- | ----- | + | |
\\ | \\ | ||
+ | [[start: |
suphybrid2/start.txt · Last modified: 2021/03/29 10:04 by support