suphybrid2:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
suphybrid2:start [2018/12/05 13:30] – support | suphybrid2:start [2021/03/29 10:04] (current) – support | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== FAQ - Hybrid-2 ====== | ====== FAQ - Hybrid-2 ====== | ||
- | * [[https://www.d-r.nl/wiki/dokudata/faq/hybrid2/HYBRID-2 RING VOLTAGE MEMO.pdf|HYBRID-2 RING VOLTAGE MEMO]] | + | ^ Model: |
+ | | Hybrid 2 || - | | ||
+ | | {{: | ||
+ | | | ||
+ | \\ | ||
+ | ^**__Question: | ||
+ | |**__Answer: | ||
+ | |Set the Send and Receive in the middle and the LC and HC to OFF.| | ||
+ | |When called in adjust the potentiometer until the lowest input signal is heared.| | ||
+ | | | | ||
+ | |The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.| | ||
+ | |So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn' | ||
+ | |When this is okay you can fine adjust the R balance.| | ||
+ | | | | ||
+ | |The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.| | ||
+ | \\ | ||
+ | ----- | ||
+ | \\ | ||
+ | * [[http:// | ||
+ | \\ | ||
+ | [[start: |
suphybrid2/start.1544013034.txt.gz · Last modified: 2018/12/05 13:30 by support