suphybrid2:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
suphybrid2:start [2019/07/26 11:30] – support | suphybrid2:start [2021/03/29 10:04] (current) – support | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== FAQ - Hybrid-2 ====== | ====== FAQ - Hybrid-2 ====== | ||
+ | |||
+ | ^ Model: | ||
+ | | Hybrid 2 || - | | ||
+ | | {{: | ||
+ | | [[http:// | ||
+ | |||
\\ | \\ | ||
- | **__Question: | + | ^**__Question: |
- | **__Answer: | + | |**__Answer: |
- | Set the Send and Receive in the middle and the LC and HC to OFF.\\ | + | |Set the Send and Receive in the middle and the LC and HC to OFF.| |
- | When called in adjust the potentiometer until the lowest input signal is heared.\\ | + | |When called in adjust the potentiometer until the lowest input signal is heared.| |
- | \\ | + | | | |
- | The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.\\ | + | |The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.| |
- | So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn' | + | |So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn' |
- | When this is okay you can fine adjust the R balance.\\ | + | |When this is okay you can fine adjust the R balance.| |
- | \\ | + | | | |
- | The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.\\ | + | |The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.| |
\\ | \\ | ||
----- | ----- | ||
\\ | \\ | ||
- | * [[https://www.d-r.nl/ | + | * [[http://www.mambanet.org/ |
- | \\ | + | |
- | ----- | + | |
\\ | \\ | ||
+ | [[start: |
suphybrid2/start.1564133428.txt.gz · Last modified: 2019/07/26 11:30 by support