supvisualradiocontrolmanual:start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| supvisualradiocontrolmanual:start [2022/08/23 15:48] – [2.1. Editing scenes] jeroenbol | supvisualradiocontrolmanual:start [2022/10/21 10:18] (current) – Add workaroud for vMix. jeroenbol | ||
|---|---|---|---|
| Line 325: | Line 325: | ||
| '' | '' | ||
| Uninstall software and install, rather then upgrade. | Uninstall software and install, rather then upgrade. | ||
| + | |||
| + | ==== 3.4. I have vMix, not OBS Studio ==== | ||
| + | |||
| + | At this moment Camcon / Visual Radio Control has only support for OBS Studio. | ||
| + | |||
| + | In order to have support for customers with vMix software, it is possible to have a little workaround to combine the two. | ||
| + | |||
| + | Setup OBS Studio to output to a network video stream. Configure this stream with little to none compression and little to none output buffering. This to reduce any additional unwanted latency. | ||
| + | |||
| + | Now setup OBS Studio to control the cameras that are needed and setup Visual Radio Control as normal. | ||
| + | |||
| + | Configure vMix to pick up the network video stream. | ||
| + | |||
| ===== Appendix A. Setting up the Camcon Software ===== | ===== Appendix A. Setting up the Camcon Software ===== | ||
supvisualradiocontrolmanual/start.txt · Last modified: 2022/10/21 10:18 by jeroenbol