Differences

This shows you the differences between two versions of the page.

--- faderstartairlab:start [2019/06/11 10:06] – support
+++ faderstartairlab:start [2022/07/18 09:18] (current) – support
@@ Line 1: / Line 1: @@
 The easiest way to change the fader start settings in an Airlab is the Airlab Control Center.\\
 Connect your Airlab to your PC by RS-232 cable or RS-232 to USB cable.\\
-Be carefull not to connect to the __Meter__ connector cause the Computer will get +15 volt and -15 volt at his data line.\\
+\\
+Be carefull not to connect to the **__Meter__** connector cause the **__+15 volt and -15 volt__** will harm the computer port.\\
+\\
 {{ :faderstartinstr:airlab_gpo_settings.png?direct |}}\\
 \\
@@ Line 12: / Line 14: @@
 \\
 [[faderstartinstr:start|Return to Fader start instructions]]\\
+\\
+[[https://www.dnrbroadcast.com/support-related|Support Request]]\\
+\\
+Go back to the [[SupAirlab:start|Airlab]] support page.\\
+\\