Differences

This shows you the differences between two versions of the page.

--- suphybrid1:start [2018/12/10 13:25] – created support
+++ suphybrid1:start [2021/04/29 16:43] (current) – support
@@ Line 1: / Line 1: @@
 ===== Hybrid 1 =====
+^  Model:  ^^  Production year  ^
+|  Hybrid 1  ||  -  |
+|  {{:hybrid-1_2015161x57_2x.jpg?250|}}  |||
+|  [[http://www.mambanet.org/assets/hybrid1-2-brochure.pdf|Brochure]]  |  [[http://www.mambanet.org/assets/telephone-hybrid-1-manual-v1.07.pdf|Manual]]  |  -  |
+\\
+^**__Question:__** How do I connect a Hybrid 1 to my mixer?^
+|**__Answer:__** Follow the instructions in this .pdf document: [[http://www.mambanet.org/wiki/dokudata/faq/hybrid2/How to connect Hybrid1.pdf|How to connect a Hybrid1]]|
+\\
+^**__Question:__** Could you give us an explanation about the dip switch of C-BALANCE?^
+|**__Answer:__** The R balance works as an N-1 and can be set with connecting the input and listening at the output.|
+|When called in adjust the potentiometer until the lowest input signal is heared.|
+|  |
+|The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.|
+|So if you apply a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn't change.|
+|When this is okay you can fine adjust the R balance.|
+|  |
+|The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.|
+\\
+[[start:|{{:iconhome.png?100|Home}}]]