Differences

This shows you the differences between two versions of the page.

--- suphybrid1:start [2020/06/12 11:32] – support
+++ suphybrid1:start [2021/04/29 16:43] (current) – support
@@ Line 1: / Line 1: @@
 ===== Hybrid 1 =====
-{{:hybrid-1_2015161x57_2x.jpg?200|}}
+^  Model:  ^^  Production year  ^
+|  Hybrid 1  ||  -  |
+|  {{:hybrid-1_2015161x57_2x.jpg?250|}}  |||
+|  [[http://www.mambanet.org/assets/hybrid1-2-brochure.pdf|Brochure]]  |  [[http://www.mambanet.org/assets/telephone-hybrid-1-manual-v1.07.pdf|Manual]]  |  -  |
 \\
 ^**__Question:__** How do I connect a Hybrid 1 to my mixer?^
-|**__Answer:__** Follow the instructions in this .pdf document: [[https://www.d-r.nl/wiki/dokudata/faq/hybrid2/How to connect Hybrid1.pdf|How to connect a Hybrid1]]|
+|**__Answer:__** Follow the instructions in this .pdf document: [[http://www.mambanet.org/wiki/dokudata/faq/hybrid2/How to connect Hybrid1.pdf|How to connect a Hybrid1]]|
 \\
 ^**__Question:__** Could you give us an explanation about the dip switch of C-BALANCE?^
 |**__Answer:__** The R balance works as an N-1 and can be set with connecting the input and listening at the output.|
-|Set the Send and Receive in the middle and the LC and HC to OFF.|
 |When called in adjust the potentiometer until the lowest input signal is heared.|
 |  |
 |The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.|
-|So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn't change.|
+|So if you apply a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn't change.|
 |When this is okay you can fine adjust the R balance.|
 |  |