Differences

This shows you the differences between two versions of the page.

--- suphybrid1:start [2021/03/29 10:04] – support
+++ suphybrid1:start [2021/04/29 16:43] (current) – support
@@ Line 12: / Line 12: @@
 ^**__Question:__** Could you give us an explanation about the dip switch of C-BALANCE?^
 |**__Answer:__** The R balance works as an N-1 and can be set with connecting the input and listening at the output.|
-|Set the Send and Receive in the middle and the LC and HC to OFF.|
 |When called in adjust the potentiometer until the lowest input signal is heared.|
 |  |
 |The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.|
-|So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn't change.|
+|So if you apply a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn't change.|
 |When this is okay you can fine adjust the R balance.|
 |  |