airlabversion:start
This is an old revision of the document!
Question: What are the differences in versions?
Answer: Link: please read the info at this link
| Version | Airlab PCB info and modifications |
|---|---|
| MK 1 | Grey coated front Master without SUB potentiometer |
| MK 1 | Grey coated front Master with SUB potentiometer and Talkback potentiometer moved |
| MK 1 | Grey coated front Channel with 48 volt Phantom power switch |
| MK 1 | Grey coated front Channel with Mono switch and 48 volt Phantom power selected by jumper |
| MK 2 | Silver coated front with added Mic insert |
| MK 2 | Silver coated front with changed side panels and Handrest with D&R logo |
| DT V.1 | Airlab 7 > Airlab PWR-MO (4 holes to adjust voltages |
| Airlab Mux 5 volt distribution circuit removed | |
| Airlab USB 5 volt connected to Airlab PWR-MO | |
| Airlab USB meter option and control surface added | |
| Airlab VU meter bridge removed | |
| Airlab 2 connect relay circuit changed to work with 5 volt relay | |
| DT V.2 | Airlab PWR-MO > Airlab PSU-A at +/- 15volt |
| DT V.3 | Airlab channel boards to SMD |
| Reedrelay at connector board removed, Opto couper placed at channel board to control fader start | |
| Airlab 2 connect relay circuit changed to work with 5 volt relay | |
| DT V.4 | Airlab master boards to SMD |
| Airlab backplane changed to Lisheng XLR |
Support Request
Go back to the Airlab support page.
airlabversion/start.1563779736.txt.gz · Last modified: 2019/07/22 09:15 by support