airlitefix:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
airlitefix:start [2020/06/12 12:11] – support | airlitefix:start [2022/07/18 09:07] (current) – support | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | \\ | ||
**__Question: | **__Question: | ||
\\ | \\ | ||
Line 117: | Line 116: | ||
\\ | \\ | ||
Remove the screws in the Red circles at the picture.\\ | Remove the screws in the Red circles at the picture.\\ | ||
+ | \\ | ||
+ | -------- | ||
+ | \\ | ||
+ | ====Where to place the AES3 module in an Airlite==== | ||
+ | \\ | ||
+ | {{: | ||
+ | \\ | ||
+ | The position of the AES3 board is on these pin strips at the backplane.\\ | ||
+ | This can be installed easily if you need an Master to AES3 output at a later moment.\\ | ||
\\ | \\ | ||
-------- | -------- | ||
Line 141: | Line 149: | ||
If you have questions, please consult the factory by filling in our Support Request form.\\ | If you have questions, please consult the factory by filling in our Support Request form.\\ | ||
\\ | \\ | ||
- | [[https:// | + | [[https:// |
\\ | \\ | ||
[[start: | [[start: | ||
airlitefix/start.txt · Last modified: 2022/07/18 09:07 by support