axumgsmhybridremote:start
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
axumgsmhybridremote:start [2022/02/15 10:59] – created support | axumgsmhybridremote:start [2022/07/18 09:18] (current) – support | ||
---|---|---|---|
Line 2: | Line 2: | ||
^**__Question: | ^**__Question: | ||
|**__Answer: | |**__Answer: | ||
+ | \\ | ||
+ | {{: | ||
+ | First you'll need to set the jumpers for one GPO to GPIO the other one remains GPO.\\ | ||
+ | For the GPIO Jack A which is GPI7 on a patch panel you'll need to change the bottom row of jumpers to 1-2 & 4-5.\\ | ||
+ | The top row remains at 2-3 & 5-6 which is GPO8.\\ | ||
+ | \\ | ||
+ | {{: | ||
+ | At a card where you connected the GSM Hybrid to you'll need to configure a GPO to switch when Start/Stop is triggered.\\ | ||
+ | You'll also need to configure a GPI to trigger the Line inputs Alert function.\\ | ||
+ | \\ | ||
+ | {{: | ||
+ | To pick up or hang up the GSM Hybrid you'll need to configure a switch for Start and Stop function.\\ | ||
+ | \\ | ||
+ | {{: | ||
+ | Now you can configure a desired LED or meters icon to input and it's Alert function to go on or blink when the GSM Hybrid rings.\\ | ||
+ | |||
+ | \\ | ||
+ | [[https:// | ||
+ | \\ | ||
+ | [[start: | ||
\\ | \\ |
axumgsmhybridremote/start.1644919164.txt.gz · Last modified: 2022/02/15 10:59 by support