enablesetup:start
This is an old revision of the document!
Question: It isn't possible to change settings of my Airlab, the Airlab won't accept/apply my settings?
Answer: Link: please follow the steps at this link
Enable setup setting
For some unknown reason the Airlab sometimes decides to disable or block the option to change settings trough the “Timer / System set-up” Display and buttons.
All settings are shown and can be toggled but the Airlab doesn't save them.
This is caused by he “Enable setup” setting which sometimes is disabled.
enablesetup/start.1587716127.txt.gz · Last modified: 2020/04/24 10:15 by support