Differences

This shows you the differences between two versions of the page.

--- enablesetup:start [2020/04/24 10:58] – support
+++ enablesetup:start [2022/07/18 09:15] (current) – support
@@ Line 11: / Line 11: @@
 All settings are shown and can be toggled but the Airlab doesn't save them.\\
 \\
-This is caused by he "Enable setup" setting which sometimes is disabled.\\
+This is caused by the "Enable setup" setting which sometimes is disabled.\\
 \\
-{{:enablesetup:airlabenablesetup.jpg?600|}}
+{{:enablesetup:airlabenablesetup.jpg?600|}}\\
 \\
 The "Enable setup" is only available in the "Airlab Control Center" software.\\
@@ Line 27: / Line 27: @@
 When connected with the delivered RS232 to USB cable it will be a "Profilic USB-to-Serial Comm port".\\
 \\
-{{:enablesetup:airlabprofilic.jpg?600|}}
+{{:enablesetup:airlabprofilic.jpg?600|}}\\
 \\
 Press "Start" to connect.\\
@@ Line 38: / Line 38: @@
 \\
 \\
-[[https://www.d-r.nl/support-request.html|Support Request]]\\
+[[https://www.dnrbroadcast.com/support-related|Support Request]]\\
-\\
-Go back to the [[SupAirlab:start|Airlab]] support page.\\
 \\
+[[start:|{{:iconhome.png?100|Home}}]][[SupAirlab:start|{{:iconback2.png?100|Back}}]]