faderstartairlab:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
faderstartairlab:start [2019/06/11 10:06] – support | faderstartairlab:start [2022/07/18 09:18] (current) – support | ||
---|---|---|---|
Line 1: | Line 1: | ||
The easiest way to change the fader start settings in an Airlab is the Airlab Control Center.\\ | The easiest way to change the fader start settings in an Airlab is the Airlab Control Center.\\ | ||
Connect your Airlab to your PC by RS-232 cable or RS-232 to USB cable.\\ | Connect your Airlab to your PC by RS-232 cable or RS-232 to USB cable.\\ | ||
- | Be carefull not to connect to the __Meter__ connector cause the Computer will get +15 volt and -15 volt at his data line.\\ | + | \\ |
+ | Be carefull not to connect to the **__Meter__** connector cause the **__+15 volt and -15 volt__** will harm the computer port.\\ | ||
+ | \\ | ||
{{ : | {{ : | ||
\\ | \\ | ||
Line 12: | Line 14: | ||
\\ | \\ | ||
[[faderstartinstr: | [[faderstartinstr: | ||
+ | \\ | ||
+ | [[https:// | ||
+ | \\ | ||
+ | Go back to the [[SupAirlab: | ||
+ | \\ | ||
+ |
faderstartairlab/start.1560240389.txt.gz · Last modified: 2019/06/11 10:06 by support