Question: How can I setup users and user levels?
Answer: Link: follow the instructions on this page.
To create Users and different User levels you'll have to follow these steps:
1. Create at the web page “Security Settings” and “Users and Levels” an Admin account first with the User level “System Administrator”.
Protect this account with a Password and click “update”.
Now you'll have an account without any restrictions.
2. Remove other accounts.
3. Go to “Securuty Settings” and “Chipcard settings”.
Insert a chipcard and refresh the website.
4. After refreshing the Lyra should show the detected chip card at surface 2.
Select “Control surface 2 chip card determines user level for control surface 1 (for 8 fader 19“ Surface)” and click update.
5. Then type “Admin name” at chip card name with it's password (2x).
Then press “write to ChipCard”.
6. Now you go to “Securuty Settings” and “Network Levels”.
Here you select of all user levels, all the functions (Also select FTP authorities) and click “update”.
It isn't possible to change the authorities of the “System Administrator”.
7. To check click “log off” at the first page of the web interface.
8. Close all browsers and wait for one minute.
If you don't close the browser the Lyra will keep alive the active connection and won't ask to log in again.
9. Open a new browser and go to the IP address of the Lyra.
10. The Lyra will now ask to log in with the user name and password.
To create extra users or to change there security levels you now have to login with the Admin account.
11. When you login with an other user you won't get the possiblity to change settings of the Lyra.
Support Request
lyrauserlevels:start
lyrauserlevels/start.txt · Last modified: 2022/07/18 09:27 by support