suphybrid1:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
suphybrid1:start [2020/01/17 14:04] – support | suphybrid1:start [2021/04/29 16:43] (current) – support | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== Hybrid 1 ===== | ===== Hybrid 1 ===== | ||
+ | |||
+ | ^ Model: | ||
+ | | Hybrid 1 || - | | ||
+ | | {{: | ||
+ | | [[http:// | ||
+ | |||
\\ | \\ | ||
- | **__Question: | + | ^**__Question: |
- | **__Answer: | + | |**__Answer: |
- | [[https://www.d-r.nl/ | + | |
\\ | \\ | ||
+ | ^**__Question: | ||
+ | |**__Answer: | ||
+ | |When called in adjust the potentiometer until the lowest input signal is heared.| | ||
+ | | | | ||
+ | |The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.| | ||
+ | |So if you apply a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn' | ||
+ | |When this is okay you can fine adjust the R balance.| | ||
+ | | | | ||
+ | |The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.| | ||
\\ | \\ | ||
- | **__Question:__** Could you give us an explanation about the dip switch of C-BALANCE? | + | [[start:|{{:iconhome.png? |
- | **__Answer:__** The R balance works as an N-1 and can be set with connecting the input and listening at the output.\\ | + | |
- | Set the Send and Receive in the middle and the LC and HC to OFF.\\ | + | |
- | When called in adjust the potentiometer until the lowest input signal is heared.\\ | + | |
- | \\ | + | |
- | The C balance should be set to the situation that the Hybrid has the lowest influence on the bus that you listen to on the mixer.\\ | + | |
- | So if you offer a testing signal to a different channel and move the fader of the Hybrid the signal at the output shouldn' | + | |
- | When this is okay you can fine adjust the R balance.\\ | + | |
- | \\ | + | |
- | The easiest way is to use a 1khz 0dB test tone for both settings and a scope but it is also possible by listening and watching the VU meters.\\ | + | |
- | \\ | + |
suphybrid1/start.1579266268.txt.gz · Last modified: 2020/01/17 14:04 by support