Differences

This shows you the differences between two versions of the page.

--- usbauxmod:start [2019/10/23 14:22] – support
+++ usbauxmod:start [2022/07/18 09:11] (current) – support
@@ Line 4: / Line 4: @@
 **__Answer:__** Link: [[usbauxmod:start|please follow the steps at this link]]
 \\
+\\
+-----
+\\
+==== This modification is standard for Version 10 with serial number 191001xx-V10 which means produced 2019-10-01 or later. ====
 \\
 -----
@@ Line 14: / Line 18: @@
 Place both Jumpers on the PCB's edge positions of the Jumper header.\\
 Solder 2 wires to this position of the Jumper headers.\\
+These pins are already connected on the PCB, for strength we suggest to solder it to both pins.\\
 Black has to be connected to Left and Green has to be connected to Right!\\
 \\
@@ Line 35: / Line 40: @@
 \\
 Solder 2 wires to this position of the Jumper headers.\\
+These pins are already connected on the PCB, for strength we suggest to solder it to both pins.\\
 Black has to be connected to Left and Green has to be connected to Right!\\
 \\
@@ Line 46: / Line 52: @@
 -----
 \\
-===== If your Left Master PCB doesn't have the 2 pin Auxilary connecter you can do it this way: =====
+===== For models that don't have the 2 pin Auxilary connector at the Master 2 (Left) PCB =====
 \\
 {{ :usbauxmod:auxtousb1.jpg?direct&800 |}}
@@ Line 56: / Line 62: @@
 \\
 Solder 2 wires to this position of the Jumper headers.\\
+These pins are already connected on the PCB, for strength we suggest to solder it to both pins.\\
 Black has to be connected to Left and Red has to be connected to Right!\\
 \\
@@ Line 65: / Line 72: @@
 \\
 \\
+If you have questions, please consult the factory by filling in our Support Request form.\\
+\\
+[[https://www.dnrbroadcast.com/support-related|Support Request]]\\
+\\
+[[start:|{{:iconhome.png?100|Home}}]][[SupAirmate:start|{{:iconback2.png?100|Back}}]]
+\\