Differences

This shows you the differences between two versions of the page.

--- enablesetup:start [2020/04/24 10:15] – created support
+++ enablesetup:start [2022/07/18 09:15] (current) – support
@@ Line 11: / Line 11: @@
 All settings are shown and can be toggled but the Airlab doesn't save them.\\
 \\
-This is caused by he "Enable setup" setting which sometimes is disabled.\\
+This is caused by the "Enable setup" setting which sometimes is disabled.\\
 \\
+{{:enablesetup:airlabenablesetup.jpg?600|}}\\
+\\
+The "Enable setup" is only available in the "Airlab Control Center" software.\\
+\\
+At the "System set-up" you won't find this setting.\\
+\\
+So to fix this connect the Airlab with it's RS232 connection to the computer with a straight RS232 to RS232 cable or a RS232 to USB cable.\\
+\\
+Download and install the "Airlab Control Center" from the software table.\\
+\\
+Start the Airlab Control Center and set the communication port to the right COMx port.\\
+\\
+When connected with the delivered RS232 to USB cable it will be a "Profilic USB-to-Serial Comm port".\\
+\\
+{{:enablesetup:airlabprofilic.jpg?600|}}\\
+\\
+Press "Start" to connect.\\
+\\
+Then "Enable" the "Enable Setup" setting.\\
+\\
+Press "Save Internal" to apply the setting.\\
+\\
+From this moment all settings can be changed again trough the "Airlab Control Center" and "System set-up".\\
+\\
+\\
+[[https://www.dnrbroadcast.com/support-related|Support Request]]\\
+\\
+[[start:|{{:iconhome.png?100|Home}}]][[SupAirlab:start|{{:iconback2.png?100|Back}}]]