enablesetup:start
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
enablesetup:start [2020/04/24 10:15] – created support | enablesetup:start [2022/07/18 09:15] (current) – support | ||
---|---|---|---|
Line 11: | Line 11: | ||
All settings are shown and can be toggled but the Airlab doesn' | All settings are shown and can be toggled but the Airlab doesn' | ||
\\ | \\ | ||
- | This is caused by he " | + | This is caused by the " |
\\ | \\ | ||
+ | {{: | ||
+ | \\ | ||
+ | The " | ||
+ | \\ | ||
+ | At the " | ||
+ | \\ | ||
+ | So to fix this connect the Airlab with it's RS232 connection to the computer with a straight RS232 to RS232 cable or a RS232 to USB cable.\\ | ||
+ | \\ | ||
+ | Download and install the " | ||
+ | \\ | ||
+ | Start the Airlab Control Center and set the communication port to the right COMx port.\\ | ||
+ | \\ | ||
+ | When connected with the delivered RS232 to USB cable it will be a " | ||
+ | \\ | ||
+ | {{: | ||
+ | \\ | ||
+ | Press " | ||
+ | \\ | ||
+ | Then " | ||
+ | \\ | ||
+ | Press "Save Internal" | ||
+ | \\ | ||
+ | From this moment all settings can be changed again trough the " | ||
+ | \\ | ||
+ | \\ | ||
+ | [[https:// | ||
+ | \\ | ||
+ | [[start: |
enablesetup/start.1587716127.txt.gz · Last modified: 2020/04/24 10:15 by support